When doing research on bathtub refinishing, you will encounter terms like resurfacing, reglazing, and re-enameling. However, they all do the same thing – they provide your tub with a brand new look. We will be discussing how bathtub refinishing works in this article.
What is Bathtub Refinishing?
You end up with the same results no matter what you call it. The surface of the bathtub is refreshed by the process to make it look brand new again. The following are important things you should know before you refinish your bathtub.
How does the process work?
Whenever possible, the drain will be removed by the contractor. That allows the coating to last for a longer period of time. When the drain cannot be removed, the contractor will need to work around it instead.
Check for cracks or nicks. Any damage that you find needs to be filled in with polyester putty and smoothed over. After the putty has dried, the old coating on the tub needs to be removed.
Professional reglazing contractors use a combination of sanding and acid etching to eliminate the coating. This treatment can be used on enamel, fiberglass, and porcelain since they are non-porous. The new layer will be unable to adhere to the surface without this step.
There are some newer processes that have been developed where etching can be skipped. If you want to choose this approach, be sure to only work with a reputable and experienced contractor. If the surface is not degreased and prepared properly, eventually the new coating will end up peeling off.
Spraying the bath is the next step that needs to be taken. Before starting this, the areas where over spray can reach will be masked off by the resurfacing contractor. From this point on, the process will start to become hazardous. This is because the chemicals that are sprayed are highly flammable and toxic.
A strong exhaust system needs to be set up by the contractor to clear away the flumes. The exhaust system helps to eliminate particles out of the air, which makes it easier for your contractor to see while they are working. Your contractor also needs to wear a specialized breathing apparatus and gloves.
Primer will be sprayed on by your bathtub refinishing contractor. To get a fine, even layer does take some skill. After it has dried, usually the contractor will apply a second and even a third layer if needed. It is worthwhile to do this extra prep work since it helps to ensure long-lasting results.
Applying the topcoat is the next step. For optimal results, two or three topcoat layers should be used at least. The new coat needs to be 5 mm thick at least, in order for the finish of the tub to be durable.
After the topcoat has dried, the drain will be replaced by the contractor and the caulk line will be refreshed as necessary.
Can I Do This On My Own?
There are kits that you can find at hardware stores to help. The drawback is they are not very effective at gripping the bathtub. Usually, these coatings will deteriorate more quickly than professional finishes will. Also, if you don’t have the right equipment for spraying it on, you could end up having brush marks.
If you need a professional tub refinisher in Tampa Florida to reglaze your bathroom fixtures, please contact our recommended sponsor: Bathtub Refinishing Pros in Tampa FL
Tampa Bathtub Refinishing Pros
3708 W Wyoming Ave
Tampa, FL 33611